
JP Instruments
Fuel Flow option for EDM-760/790, Without transducers, Harness included
Fuel Flow option for EDM-760/790 without transducers; harness included
No reviews yetSKU JPI FF-760-790
$875.00
In stock — ready to ship
- Ships in 1–2 days
- Genuine parts
- Pilot support
- 30-day returns
Fuel Flow option for JP Instruments EDM-760/790 sold without transducers; harness is included.
Important Information
- Mounting orientation requirement and failure consequence.
- Refer to product report for installation details.
- Mount in horizontal position with wires up to ensure rotor orientation as calibrated.
- Do not place bends within 6 inches of the transducer; do not use aluminum fittings.
- Carbureted engine installation and anti-siphon loop guidance.
- Placement recommendations for injected engines and vapor return lines.
- Do not mount between electric boost pump and mechanical pump (not recommended).
- Do not hard mount to the engine; vibration may damage internal parts or cause erratic readings.
- Fitting torque/turn limit.
- Do not use Teflon tape or any thread sealant; doing so will void the transducer warranty.
- Can be added to most EDM instruments plug-and-play; exception for EDM-760/700 models.
- Transducers produce a current pulse signal from an opto-electronic pickup with a preamplifier.
- Repeatable signals on gasoline across a 100 to 1 flow range down to 0.3 GPH; diesel repeatability reduced below 2 GPH.
- Transducer bearing system rated for continuous operation at the upper end of the flow range.
- Pressure drops are very low compared to other turbine flow transducers.
- K-factor and linearity characteristics provided for range variants.
Electrical & RF
- Operating Voltage
- 12 to 15 VDC between RED (+) wire and BLACK (-) wire.
- Output Current
- 30 to 50 mA at 12 VDC.
Construction
- Connection Type
- Open collector transistor output on WHITE wire. Sensor will pull-down to 1.0 volt with 10-15k ohm pull-up resistor installed.
In the box
- Included Components
- Fuel Flow option for EDM-760/790, Without transducers, Harness included
General
- Flow Rate
- Range (201) 0.6 to 60 GPH, (231) 3 to 90 GPH, (H) 3 to 120 GPH
You may also like
Customer reviews
—/ 5
No reviews yet
5★
0
4★
0
3★
0
2★
0
1★
0
Loading reviews…










