
JP Instruments
Fuel Flow option for EDM-700, With 201 transducer, Harness included
Fuel flow option kit for EDM-700 with Model 201 transducer and harness
$475.00
In stock — ready to ship
- Ships in 1–2 days
- Genuine parts
- Pilot support
- 30-day returns
Fuel Flow option kit for the EDM-700 using JP Instruments Fuel Flow Transducer Model 201B-9 (old264) with harness included.
Important Information
- Adding Fuel Flow to existing units requires returning the unit to JPI for adjustments.
- Do not use Teflon tape or thread sealant compound of any kind – this will void transducer warranty.
- Please refer to Report #503 that came with your EDM with Fuel Flow.
- Make sure the transducer is Horizontal with the three wires up; failure to do so will result in premature failure.
- Be sure there is no bend in the line closer than 6 inches before or after the transducer.
- Do not use aluminum fittings when installing the fuel flow transducer.
- For carbureted engines, install before the carburetor; if transducer is higher than carburetor, add an anti-siphon loop that peaks higher than the transducer.
- For injected engines, install between the engine fuel pump and the servo regulator; for injected engines with vapor return lines, between the servo regulator and the flow divider.
- Mounting the transducer between the electric boost pump and the mechanical pump is not recommended.
- Do not hard mount the transducer to the engine; vibration may damage internal parts or cause erratic readings.
- Tighten fittings not more than 15 ft lb = 180 in lbs., or two full turns past hand tight.
- ** Do not use Teflon tape or thread sealant compound of any kind – this will void transducer warranty.**
- Measures flows of hydrocarbon fuels and other light transmitting, non-corrosive liquids of similar viscosity
- Gives repeatable signals on gasoline across a wide flow range
- Produces a current pulse signal from an opto-electronic pickup with a preamplifier
- Low pressure drop compared to other turbine flow transducers
- Bearing system rated for continuous operation at upper end of flow range
Part numbers
- Manufacturer Part Number
- 201B-9 (old264)
Electrical & RF
- Input Voltage
- 12 to 15 VDC between RED (+) wire and BLACK (-) wire.
- Output Current
- 30 to 50 mA at 12 VDC.
Construction
- Connection Type
- Open collector transistor output on WHITE wire. Sensor will pull-down to 1.0 volt with 10-15k ohm pull-up resistor installed.
- Pressure
- Pressure drop (201) 1.2 psi at 30 GPH, 4.8 psi at 60 GPH Pressure drop (231) 0.31 psi at 30 GPH, 2.8 psi at 60 GPH Pressure drop (H) 0.23 psi at 30 GPH, 0.8 psi at 60 GPH Working pressure (201, 231) 200 psi, (H) 1500 psi Maximum burst pressure 2000 psi
In the box
- Included Components
- 201 transducer; Harness included
General
- Flow Rate
- Range (201) 0.6 to 60 GPH, (231) 3 to 90 GPH, (H) 3 to 120 GPH
You may also like
Customer reviews
—/ 5
No reviews yet
5★
0
4★
0
3★
0
2★
0
1★
0
Loading reviews…










