
JP Instruments
Fuel Flow option for EDM-730, Without transducer, Harness included
Fuel Flow option for JPI EDM-730; harness included; transducer not included
No reviews yetSKU JPI FF-730
$205.00
In stock — ready to ship
- Ships in 1–2 days
- Genuine parts
- Pilot support
- 30-day returns
Fuel Flow option for the JP Instruments EDM-730 that includes a harness but does not include the transducer.
Important Information
- Do not use Teflon tape or thread sealant compound of any kind — will void transducer warranty
- Mount transducer horizontal with wires up; failure to do so may cause premature failure
- Refer to Report #503 that came with the EDM with Fuel Flow
- Do not use aluminum fittings; avoid bends within 6 inches before or after the transducer
- Do not hard mount the transducer to the engine; vibration may damage internal parts or cause erratic readings
- Tighten fittings not more than 15 ft lb = 180 in lbs., or two full turns past hand tight
- Mounting advice for carbureted and injected engines (placement and anti-siphon loop guidance)
- Recommended installation location for injected engines and note on vapor return lines
- For injected engines with vapor return lines, mount between the servo regulator and the flow divider
- Mounting between electric boost pump and mechanical pump is not recommended
- EDM option can be added at any time; plug-and-play (no instrument return required)
- Produces a current pulse signal from an opto-electronic pickup with a preamplifier
- Gives repeatable signals on gasoline across a 100 to 1 flow range down to 0.3 GPH
- Transducer bearing system rated for continuous operation at the upper end of the flow range
Electrical & RF
- Operating Voltage
- 12 to 15 VDC between RED (+) wire and BLACK (-) wire
- Output Current
- 30 to 50 mA at 12 VDC
Construction
- Condition
- Without transducer
- Connection Type
- Open collector transistor output on WHITE wire
In the box
- Included Components
- Harness
General
- Output Voltage
- Sensor will pull-down to 1.0 volt with 10-15k ohm pull-up resistor installed
- Flow Rate
- (201) 0.6 to 60 GPH; (231) 3 to 90 GPH; (H) 3 to 120 GPH
You may also like
Customer reviews
—/ 5
No reviews yet
5★
0
4★
0
3★
0
2★
0
1★
0
Loading reviews…










