
JP Instruments
Fuel Flow option for EDM-730, With 231 transducer, Harness included
Fuel flow option for EDM-730 with Model 231 transducer and harness.
No reviews yetSKU JPI FF-231-730
$495.00
In stock — ready to ship
- Ships in 1–2 days
- Genuine parts
- Pilot support
- 30-day returns
Fuel Flow option for EDM-730 including JP Instruments Fuel Flow Transducer Model 231 and harness.
Important Information
- Make sure the transducer is Horizontal with the three wires up. Failure to do this will result in premature failure. Please refer to Report #503 that came with your EDM with Fuel Flow.
- Do not use aluminum fittings when installing the fuel flow transducer.
- Be sure there is no bend in the line closer than 6 inches before or after the transducer.
- Do not hard mount the transducer to the engine. Vibration may damage the internal parts of the transducer or cause erratic readings.
- Mounting the transducer between the electric boost pump and the mechanical pump is not recommended.
- Tighten fittings not more than 15 ft lb = 180 in lbs., or two full turns past hand tight.
- ** Do not use Teflon tape or thread sealant compound of any kind – this will void transducer warranty.**
- JP Instruments Fuel Flow Transducer Model 231 Not compatible with 9-cylinder engines
- Be sure there is no bend in the line closer than 6 inches before or after the transducer. Do not use aluminum fittings when installing the fuel flow transducer.
- The transducers give repeatable signals on gasoline across a 100 to 1 flow range down to 0.3 GPH.
- Pressure drops are very low compared to other turbine flow transducers.
- The transducer bearing system is rated for continuous operation at the upper end of the flow range.
- The transducers produce a current pulse signal from an opto-electronic pickup with a preamplifier.
- Linearity 1%
Size & weight
- Capacity
- 3 to 90 GPH
Electrical & RF
- Operating Voltage
- 12 to 15 VDC between RED (+) wire and BLACK (-) wire.
- Output Current
- 30 to 50 mA at 12 VDC.
Construction
- Connection Type
- Open collector transistor output on WHITE wire. Sensor will pull-down to 1.0 volt with 10-15k ohm pull-up resistor installed.
- Pressure
- Pressure drop (231) 0.31 psi at 30 GPH, 2.8 psi at 60 GPH; Pressure drop (H) 0.23 psi at 30 GPH, 0.8 psi at 60 GPH; Working pressure (201, 231) 200 psi, (H) 1500 psi; Maximum burst pressure 2000 psi
In the box
- Included Components
- Fuel Flow option for EDM-730, With 231 transducer, Harness included
Engines
Not compatible with 9-cylinder engines
You may also like
Customer reviews
—/ 5
No reviews yet
5★
0
4★
0
3★
0
2★
0
1★
0
Loading reviews…










