
JP Instruments
Fuel Flow option for EDM-730, With 201 transducer, Harness included
Fuel Flow option for EDM-730 with Model 201B-9 transducer and harness
No reviews yetSKU JPI FF-201-730
$495.00
In stock — ready to ship
- Ships in 1–2 days
- Genuine parts
- Pilot support
- 30-day returns
JP Instruments Fuel Flow Transducer Model 201B-9 fuel flow option for the EDM-730; harness included.
Important Information
- Transducer must be installed horizontal with the three wires up; failure to do so may cause premature failure.
- Mounting orientation and piping requirements: mount horizontal with wires up; no bend within 6 inches before or after; do not hard mount.
- Fitting torque limit: tighten fittings not more than 15 ft lb = 180 in lbs., or two full turns past hand tight.
- Do not use Teflon tape or thread sealant compound of any kind; this will void transducer warranty.
- JP Instruments Fuel Flow Transducer Model 201B-9 (old264) Not compatible with 9-cylinder engines
- Be sure there is no bend in the line closer than 6 inches before or after the transducer. Do not use aluminum fittings when installing the fuel flow transducer.
- Mounting the transducer between the electric boost pump and the mechanical pump is not recommended.
- ** Do not use Teflon tape or thread sealant compound of any kind – this will void transducer warranty.**
- Measures flows of hydrocarbon fuels and similar light, non-corrosive liquids
- Repeatable signals on gasoline across a 100:1 flow range down to 0.3 GPH
- Transducer bearing system rated for continuous operation at upper end of flow range
- Produces current pulse signal from an opto-electronic pickup with a preamplifier
- Low pressure drops compared to other turbine flow transducers
- Linearity 1%
- K-factor values for models: (201) ~29.00, (231) ~19.50, (H) ~48.00
- Operating temperature and non-operating temperature ranges provided
Electrical & RF
- Operating Voltage
- 12 to 15 VDC between RED (+) wire and BLACK (-) wire.
- Output Current
- 30 to 50 mA at 12 VDC.
Construction
- Connection Type
- Open collector transistor output on WHITE wire; sensor will pull-down to 1.0 volt with 10-15k ohm pull-up resistor installed.
- Pressure
- Pressure drop (201) 1.2 psi at 30 GPH, 4.8 psi at 60 GPH; (231) 0.31 psi at 30 GPH, 2.8 psi at 60 GPH; (H) 0.23 psi at 30 GPH, 0.8 psi at 60 GPH; Working pressure (201, 231) 200 psi, (H) 1500 psi; Maximum burst pressure 2000 psi
In the box
- Included Components
- Fuel Flow Transducer Model 201B-9 (old264); Harness included
General
- Flow Rate
- Range (201) 0.6 to 60 GPH, (231) 3 to 90 GPH, (H) 3 to 120 GPH
Engines
Not compatible with 9-cylinder engines
You may also like
Customer reviews
—/ 5
No reviews yet
5★
0
4★
0
3★
0
2★
0
1★
0
Loading reviews…










