
JP Instruments
Fuel Flow option for EDM-700, Without transducer, Harness included
Fuel Flow option for EDM-700, Without transducer, Harness included
No reviews yetSKU JPI FF-700
$199.00
In stock — ready to ship
- Ships in 1–2 days
- Genuine parts
- Pilot support
- 30-day returns
Fuel Flow option for the EDM-700 model (product sold without transducer; harness included).
Important Information
- Adding Fuel Flow to existing units requires returning the unit to JPI for adjustments.
- Mounting orientation requirement: transducer must be horizontal with wires up to avoid premature failure.
- Do not use Teflon tape or thread sealant; doing so voids the transducer warranty.
- Installation restrictions: avoid bends within 6 inches of the transducer and do not use aluminum fittings.
- Tighten fittings not more than 15 ft lb = 180 in lbs., or two full turns past hand tight.
- Measures flows of hydrocarbon fuels (gasoline, kerosene, #2 diesel and similar liquids).
- Provides repeatable signals on gasoline across a wide flow range (down to 0.3 GPH).
- Current-pulse output from an opto-electronic pickup with preamplifier.
- Low pressure drop compared to other turbine flow transducers.
- Bearing system rated for continuous operation at the upper end of the flow range.
Size & weight
- Size
- Fuel ports (201, 231) 1/4 Female NPT; (H) AN816-8-8
Electrical & RF
- Operating Voltage
- 12 to 15 VDC between RED (+) wire and BLACK (-) wire.
- Output Current
- 30 to 50 mA at 12 VDC.
Construction
- Condition
- Without transducer
- Connection Type
- Open collector transistor output on WHITE wire; sensor will pull-down to 1.0 volt with 10-15k ohm pull-up resistor installed.
In the box
- Included Components
- Harness included
General
- Flow Rate
- Range (201) 0.6 to 60 GPH, (231) 3 to 90 GPH, (H) 3 to 120 GPH
You may also like
Customer reviews
—/ 5
No reviews yet
5★
0
4★
0
3★
0
2★
0
1★
0
Loading reviews…










